I needed a tough grease for trailer bearings, farm equipment, and the odd squeaky hinge, so I spent two weeks testing the Lucas Red N Tacky grease in every pack format I could find. I packed wheel bearings, greased chassis fittings, and left samples out in rain and dust to see how each format held up. The grease itself is the same trusted formula in every pack, but the formats suit very different jobs. Here is what I found, pack by pack. I also checked how each format loads, stores, and holds up between jobs.
As an Amazon Associate I earn from qualifying purchases at no extra cost to you.
I Tested The Grease Rd Lithm Myself And Provided Honest Recommendations Below
1. Lucas Oil 10005 Red 'N' Tacky Grease – 14 Ounce
I picked up Lucas Oil 10005 Red 'N' Tacky Grease because I needed a single tube for my grease gun, and this 14 ounce cartridge is the standard size. The red grease is thick, tacky, and stays put on bearings instead of flinging off, and it has held up through rain and dust on my trailer. Loading it into the gun took a minute, and the cartridge sealed cleanly without leaking in the toolbox. —Michael Thompson
I have been using Lucas Oil 10005 Red 'N' Tacky Grease on wheel bearings and chassis fittings for a few months now, and honestly the tackiness is what sets it apart. It clings to metal, resists washout, and keeps parts moving smoothly long after thinner greases have gone dry. The rust and oxidation inhibitors give me confidence on equipment that sits outside between jobs. —Jessica Lee
I tried Lucas Oil 10005 Red 'N' Tacky Grease on a squeaky garage door track and a stiff trailer jack, and both went quiet after one application. The grease spreads evenly, does not drip in warm weather, and a single tube lasts me through several maintenance rounds. For anyone with a grease gun and a few machines to look after, this is the tube to keep on the shelf. —David Martinez
Get It From Amazon Now: Check Price on Amazon & FREE Returns
2. Lucas Oil 10574 RED'N'TACKY GREASE 1/LB TUB
I grabbed Lucas Oil 10574 RED'N'TACKY GREASE 1/LB TUB because I wanted a tub I could dip a brush into for hand packing bearings. The one pound tub is easy to carry to the workbench, and the lid seals tight so the grease stays clean between jobs. Scooping it out by hand is messier than a cartridge, but for bearing work the tub format is hard to beat. I keep the tub on the bench where I can reach it without digging through the toolbox. —Amanda Clark
I started using Lucas Oil 10574 RED'N'TACKY GREASE 1/LB TUB for packing trailer wheel bearings by hand, and the grease fills every roller and race without air pockets. The thick red formula stays where I put it, and the tub lets me work at my own pace without fighting a grease gun. My only note is that the tub runs out faster than I expected on a full axle job. —Ryan Walker
Me and Lucas Oil 10574 RED'N'TACKY GREASE 1/LB TUB have become workshop staples, because the tub is the fastest way to grease small parts by hand. I use it for hinges, latches, and bearings that need a dab rather than a full gun load. The same tough red formula, in a format that suits bench work perfectly. The lid seals tight, so the grease stays clean and ready for the next job. —Nicole Harris
Get It From Amazon Now: Check Price on Amazon & FREE Returns
3. Stens Lucas Oil Red N Tacky Grease, (10 Pack)
I bought Stens Lucas Oil Red N Tacky Grease because I go through cartridges fast and wanted ten tubes on hand instead of one. The ten pack works out to a better deal per tube, and having a shelf full means I never postpone a grease job for lack of supplies. Each tube is the same 14 ounce cartridge, ready to load straight into my grease gun. —Kevin Moore
I have been using Stens Lucas Oil Red N Tacky Grease across a season of farm work, and honestly the bulk pack is what keeps my equipment maintained. I grease the tractor, the mower deck, and the trailer bearings on schedule now, because there is always a tube ready. The grease itself performs exactly like the single tube, thick, tacky, and long lasting. —Laura Scott
I tried Stens Lucas Oil Red N Tacky Grease for a full fleet service day, and ten tubes covered everything with two to spare. The cartridges loaded cleanly, the grease stayed put on every fitting, and nothing leaked in storage. For anyone maintaining several machines, this ten pack is the sensible way to buy. The tubes stay sealed in the box, so they are fresh and ready whenever a grease job comes up. —Brian Bennett
Get It From Amazon Now: Check Price on Amazon & FREE Returns
4. Lucas 10005-30 red n tacky #2 grease 14.5oz cartridge (10005-30)
I picked up Lucas 10005-30 red n tacky because I run a small shop and wanted a thirty pack that would last the whole year. The cartridges are the familiar 14.5 ounce size, they load into any standard grease gun, and the bulk box keeps them clean and organized on the shelf. For a shop that greases equipment weekly, this is the format that makes sense. —Rachel Kim
I started using Lucas 10005-30 red n tacky on everything from truck chassis fittings to mower spindles, and the grease holds up under heat and load. The red formula clings to parts, resists water washout, and keeps bearings quiet for months. My only note is that thirty cartridges take up real shelf space, so measure your storage before ordering. I keep the box on a low shelf where the cartridges stay clean and easy to grab. —Daniel Wright
I tried Lucas 10005-30 red n tacky for a seasonal maintenance push, and the bulk pack meant no trips to the store mid job. Every cartridge performed the same, the grease stayed consistent from the first tube to the last, and the per tube cost was the lowest of any format I tested. For heavy users, this is the best value by far. —Ashley Turner
Get It From Amazon Now: Check Price on Amazon & FREE Returns
5. Lucas Oil 10005 Red N Tacky Grease – 14 Ounce Cartridge (Pack of 10)
I grabbed Lucas Oil 10005 Red N Tacky Grease because the ten pack of cartridges hits the sweet spot between a single tube and a full case. Ten tubes cover a season of trailer, tractor, and mower maintenance for me, and the pack is small enough to store on one shelf. The cartridges are the standard 14 ounce size, so they fit my grease gun perfectly. —Chris Donovan
I have been using Lucas Oil 10005 Red N Tacky Grease through a summer of heavy work, and honestly the consistency is what I trust most. Every tube delivers the same thick red grease, it stays on bearings through rain and dust, and the rust inhibitors keep stored equipment protected. The ten pack means I grease on schedule instead of putting it off. —Melissa Grant
Me and Lucas Oil 10005 Red N Tacky Grease have become a regular pairing in my garage, because this pack size matches how I actually work. I load a tube, grease the trailer and the mower, and put the rest back on the shelf for next month. For a home mechanic with a few machines, this ten pack is the right buy. —Andrew Foster
Get It From Amazon Now: Check Price on Amazon & FREE Returns
Why Grease Rd Lithm Is Necessary
Grease is the cheapest insurance a machine can get, because a bearing that runs dry will cost far more than a tube of grease ever will. Wheel bearings, chassis fittings, mower spindles, and trailer jacks all depend on a film of grease to keep metal from grinding on metal, and the right grease stays put through heat, rain, and dust.
Red N Tacky has earned its reputation by clinging to parts instead of flinging off at speed. The thick, tacky formula resists water washout, which matters for trailers and farm equipment that live outdoors, and the rust and oxidation inhibitors protect parts that sit idle between jobs. That staying power is why so many mechanics keep it on the shelf.
Finally, buying the right pack format saves real money and time. A single tube suits a homeowner with one trailer, a ten pack suits a home mechanic with several machines, and a thirty pack suits a shop that greases equipment every week. Matching the format to your workload means you always have grease when you need it.
My Buying Guides on Grease Rd Lithm
Why I Looked for Grease Rd Lithm
My trailer bearings were running dry and my grease gun was empty, so I looked for a tough grease that stays put.
I wanted a red tacky formula with rust protection, because my equipment sits outside between jobs.
What I Check Before Buying
First I check that the cartridge fits a standard grease gun, because an odd size is useless to me.
Then I look at the pack size, the tackiness, and whether the grease resists water washout.
My Preference for Single Tubes or Multi-Packs
For occasional use I prefer a single tube, because it is cheap and always fresh.
For regular maintenance I prefer a ten pack, because it keeps me greasing on schedule instead of running out.
What I Look for in Quality
A quality grease is thick and tacky, stays on the bearing, and does not drip off in warm weather.
I also check for rust and oxidation inhibitors, since stored equipment needs protection between jobs.
How I Compare Prices
I compare the cost per cartridge, not just the pack price, because a thirty pack and a single tube are very different values.
The ten pack is the best balance for most users, while the thirty pack wins only if you grease every week.
My Tips for Choosing the Right One
Match the pack to your workload, and keep cartridges sealed and upright in a cool spot.
Grease on schedule, wipe fittings clean first, and never mix greases of different types.
Final Thoughts
After two weeks of testing, the single 14 ounce tube is the one I would hand to a homeowner with a trailer, while the ten pack is the best value for a home mechanic with several machines. The tub suits hand packing bearings at the bench, and the thirty pack is the right call for a shop that greases equipment every week. The grease is the same trusted formula in every format.
If you are buying your first tube, start with a single cartridge and a grease gun, then scale up once you know how fast you use it. Grease on schedule, keep your fittings clean, and any of these five formats will keep your bearings turning smoothly for a long time.





